ram air

[KIZER24]

does anyone have any ideas about ram air for a 93 sohc automatic??????
All i have seen are manual and i have been screwin around with ideas for mine but cant quite figure out how to get any type of piping down to the airdam.
Also have aftermarket conical filter and removed the main pipe with the resonator.
help anyone

[detpac]

I've seen a post, on 3SI board that showed a ram air technique with PVC tubing (not pipe) and duct tape and a dryer exhaust hood/vent. It looked ok but I do not know how well it worked or helped.

[Racer 007]

I have also heard that RAM air is that it isn't really that effective until you reach speeds of about 100mph and above.

Pretty much useless at lower speeds.

[detpac]

It would be Cold Air Intake before that though. That would be better than nothing. Also, make a cold air wall with that mod and you would be in business.

[wicked_blue24]

Well I finally did it yall. Sohc atx ram air. Had to relocate a few minor things though. There is really are serious improvement with the cold air.I have to find a new launcch rpm.My 201300 mile base spins em with an atx thanks to the new mod.

[detpac]

Good job.

[extremestereo]

post some pics if ya can.

[wicked_blue24]

Good news and bad. The ram air worked. My 1/4 was 16.7 with ram air. 16.5 with no hood and ram air removed. Filter was so nasty from ram air wont put it back on the same way. It ran 16.9 with hood and no ram air. Gonna find a way to do it with out taping the hose to the filter so I can remove all of the bugs and shit without redoing it. Then I will take some pics.